Items to check before the start of the rotary mechanical grille

When the rake tooth chain runs to the upper part of the equipment, due to the guidance of the sheave wheel and the bent rail, each group of rake teeth produces a relatively self-cleaning movement, and most of the solid matter falls by gravity. The other part relies on the reverse movement of the cleaner to clean up the debris stuck to the rake teeth.

The rake tooth chain is similar to the grille according to the direction of the water flow, and the rake tooth gap assembled on the rake tooth chain shaft can be selected according to the conditions of use. When the rake teeth separate the solid suspended solids in the fluid, the water can flow smoothly. The whole work process is continuous or intermittent.

High degree of automation, high separation efficiency, small power consumption, no noise, good corrosion resistance, can ensure continuous and stable work in the case of unattended, set up an overload safety protection device, in the event of equipment failure, will produce sound and light alarm and automatic shutdown, can avoid equipment overload.

The equipment can arbitrarily adjust the equipment operation interval according to the user's needs to achieve periodic operation; It can be automatically controlled according to the liquid level difference before and after the grille; And there is a manual control function to facilitate maintenance. Users can choose according to different work needs.

Due to the reasonable structural design of the equipment, when the equipment is working, it has a strong self-cleaning ability and will not be blocked, so the daily maintenance workload is very small.

Operational precautions

1. Check before starting

(1) The two ends of the rotary mechanical grille grating rod are fixed structures, but in the process of transportation and handling, due to improper operation, the tail of the grating rod will leave the fixed seat, so it is necessary to check and confirm that each grating is in a fixed state before starting. If there is a grating rod with the tail detached from the fixer. Then put its tail into the corresponding small hole of the fixer, and pay attention to not have more than two grille rods placed between the two adjacent rake teeth at the same time.

(2) The grille rod shall not be bent and deformed.

(3) The rotary mechanical grille rake teeth can rotate between the grille rods.

(4) Confirm the tightness of the chain, although it has been adjusted at the time of delivery, but in the process of transportation and handling, due to improper operation, the chain will be improperly tightened, please adjust it according to (daily maintenance precautions).

HOT NEWS