The Integrity Tester provides fully automated analysis of filter integrity. The integrity test detects small amounts of flow through the sample before the bubbl...
info@qinsun-lab.comThe Integrity Tester provides fully automated analysis of filter integrity. The integrity test detects small amounts of flow through the sample before the bubble point is reached. The user-friendly Integrity Analyzer features non-destructive testing and can test a wide variety of samples. The integrity test can also measure bubble point.
Operation Principle
A fully wetted sample is placed in the sample chamber and the chamber is sealed. Gas is then allowed to flow into the chamber behind the sample with increasing pressure. A flow meter is located in front of the sample and is used to detect gas flow through the sample prior to any pore being emptied of liquid, thus, the integrity is determined. When the pressure reaches a point that can overcome the capillary action of the liquid within the largest pore, the bubble point has been found. After determination of the bubble point, the pressure is increased and the flow is measured until all pores are empty.
Application
Industries worldwide use the Integrity Analyzer for R&D and quality control. Samples often tested include filter media, membranes, paper and battery separators.
Features
Allows testing of sample under tension, compression, or elevated temperature to simulate actual operating conditions
Determines gas permeability of nearly impermeable samples (microflow permeability)
Windows-based software handles all control, measurement, data collection, and report generation; manual control also possible
Real-time graphical test display depicts testing status and results throughout operation
Nondestructive testing
Length of test less than 30 minutes
Wide range of acceptable sample sizes and types
Transparent sample chamber for visual confirmation
Minimal maintenance required
Items | Parameters |
Pore Size Range: | 0.013 - 500 microns |
Permeability Range: | 1 x 10 - 50 darcies |
Sample Size: | 1.75” - 2.5” diameter |
Pressure Range: | 0 - 500 psi |
Pressurizing Gas: | Clean dry, and compressed air or non-ammable and non-corrosive gas |
Pressure Transducer Range: | 0 - 500 psi |
Resolution: | 1 in 20,000 |
Accuracy: | 0.15% of reading |
Mass Flow Transducer Range: | 10 cm/min - 500,000 cm/min |
Power Requirements: | 110/120 VAC, 50/60 Hz (others available) |
Dimensions: | 30” H x 19” W 18.5” D |
You can also send a message to us by this email info@qinsun-lab.com, we will reply tu you within 24 hours.Now tell us your need,there will be more favorable prices!
Home |
Product |
About |
Contact
Email: info@qinsun-lab.com
No.258 Ban Ting road, Song Jiang district, Shanghai