Operation method and maintenance of belt conveyor

How to operate the conveyor:

1. The fixed conveyor should be installed on a fixed basis according to the prescribed installation method. Before the mobile conveyor is officially put into operation, the wheels should be wedged with a triangle or braked. In order to avoid walking around in the work, when there are multiple conveyors operating in parallel, there should be a one-meter passage between the machine and the machine, and between the machine and the wall.

2. Before the conveyor is used, it is necessary to check whether the running parts, belt buckles and bearing devices are normal, and whether the protective equipment is complete. The tension of the tape must be adjusted to the appropriate level before starting.

3. The belt conveyor should be started without load. Wait for normal operation before feeding. It is forbidden to enter the material first and then drive.

4. When there are several conveyors running in series, they should start from the unloading end and start in sequence. After all the normal operation, the material can be fed.

5. When the belt deviates during operation, it should be stopped for adjustment and should not be used reluctantly, so as not to wear the edge and increase the load.

6. The temperature of the working environment and the materials to be sent shall not be higher than 50 °C and lower than -10 °C. Materials with acidic and alkaline oils and organic solvents shall not be conveyed.

7. Pedestrians or passengers are prohibited on the conveyor belt.

8. Before stopping, the feeding must be stopped, and the parking can only be stopped when the material on the belt is unloaded.

9. The conveyor motor must be well insulated. Do not pull and drag the mobile conveyor cable. The motor should be reliably grounded.

10. It is strictly forbidden to pull the belt with your hands when the belt is slipping, so as to avoid accidents.

Belt conveyor maintenance: In order to ensure the reliable operation of the belt conveyor, the most important thing is to find and eliminate possible faults in time. To this end, the operator must observe the working condition of the conveyor at any time, and deal with it in time if any abnormalities are found. It is important that mechanical workers make regular rounds and inspect any situations or components that require attention. An idler, for example, may not be important, but a high-speed belt that conveys wear material can quickly wear through its shell, leaving a cutting edge that can seriously damage an expensive belt. Trained workers or experienced workers can detect impending accidents in time and prevent them before they occur. The belt of the belt conveyor accounts for a considerable proportion of the overall conveyor cost. In order to reduce the cost of replacing and repairing conveyor belts, it is necessary to pay attention to the training of operators and maintenance personnel on the operation and maintenance knowledge of conveyor belts.

HOT NEWS